How do you care for a Rubber plant (Ficus elastica)?
The rubber plant is an evergreen with large, thick, glossy leaves on an upright stem. It is native to parts of South and Southeast Asia, where it grows as a tree. Indoors, it can become a substantial floor plant, but usually grows at a manageable pace. It does best with steady conditions and room for its leaves.
How much light does a Rubber plant need?
Place it near a bright window with filtered light. It can manage lower light, but growth may slow and the plant may become leggy. A little gentle morning sun can suit it; introduce stronger direct sun gradually, since leaves can scorch after an abrupt move.
How often should you water a Rubber plant?
Water when the top few centimetres of mix feel dry, rather than by a calendar. Check with a finger and lift the pot; a lighter pot often signals that it has dried. Water thoroughly, then empty the saucer. If the mix stays wet, wait and check drainage before watering again.
What is wrong with my Rubber plant?
- Rubber plant yellow leaves: causes and what to check: Several yellow leaves on a rubber plant often point to potting mix staying wet too long, especially in low light. First feel the mix a few centimetres down and check that the pot drains freely.
- Rubber plant wilting: causes and what to check: For a rubber plant, wilting often follows dry potting mix, but waterlogged roots can cause similar drooping. First feel the mix several centimetres down and lift the pot before deciding whether to water.
- Rubber plant brown or black spots: causes and what to check: On rubber plants, dark spots often follow a mix kept too wet or prolonged moisture around leaves, though scorch and cold injury can look similar. First check whether the spots are dry or wet and whether the potting mix is still damp.
- Rubber plant leaves curling: causes and what to check: On a rubber plant, leaves often curl when the root ball has become too dry, though pests or wet, stressed roots can look similar. First inspect new leaves and their undersides, then feel the mix below the surface.
- Rubber plant hard bumps: causes and what to check: On rubber plants, separate, firmly attached bumps along woody stems are often scale insects. Check whether each bump lifts from the surface, and look for sticky residue under leaves or near stem joints before removing anything.
Full Rubber plant care guide on PlantPal →